Green & gold Friendly Plastic mask

My step daughter asked me if I could make a mask similar to the one I had made for my daughter:

but in greens.

A mask takes between 3 and 4 sticks of Friendly Plastic, so I checked my stash and found 2 iridescent green sticks and 2 gold. I cut one of the gold sticks in half and then cut each half lengthwise into 7 strips. I did the same with one of the green strips.


I have a paper mache mask form, which I covered in aluminium foil, so that the Friendly Plastic wouldn't stick to it.


I then set my melting pot to 140 degrees and filled it with water. I dropped a gold strip into the water, coloured side down, and after about 10 seconds I fished it out (using a wooden handled pointy tool), and laid it onto the mask form. I repeated with all my gold strips, until I had my mask base. I pressed the pointy tool into each joint as I worked, the joints are what holds the mask together and I wanted them to be as strong as possible.


I topped up the water, and repeated the process using the green strips, overlapping and joining onto the gold strips as I went.


Next, I put a green strip onto a piece of non stick craft sheet and heated it with my craft gun until soft. I pushed a cutter into the Friendly Plastic then dropped the craft sheet, plastic and cutter into a bowl of cold water. After 10 seconds I took it all out, removed the cutter, peeled the plastic off the craft sheet and used sharp scissors to separate the shape I had cut out from the plastic. I repeated with the green and gold until I had 6-8 shapes of each colour.


I heated the centre of the mask with my heat gun, just enough to make it tacky, then laid a shape at top centre, and continued heating until I could see the shape was soft. I pushed into the shape with the end of the pointy tool - this gave a 'crease' down the 'petal' and also pushed the shape firmly into the layer below, making a strong joint.

I repeated with more heat and more shapes until the mask was finished. You need to be careful not to apply too much heat at once, or the mask will melt so much that it loses definition and oozes off the foil...


Once happy with the mask, I left it to cool on the mask form for an hour or so, then just popped it off.


All it needs now is elastic!

Friendly plastic mask

My daughter is going to a masquerade ball next week. She was going to go shopping for a burgundy and gold mask, to go with her dress. I said I was sure I could make something unique for her instead, and this is what I came up with:


I took a blank mask and covered it in tin foil. I cut thin strips from a gold FP stick, and softened them in water, then used a pointed tool to lift them out of the water and lay them randomly onto the tin foil covered mask. I bent them so that each strip changed direction a couple of times, and made sure they crossed over and joined onto other strips. Once I had a reasonable base, I started cutting strips off an indian red strip, and added those to fill some of the gaps and add strength. When I was happy with this base, I heated it with a heat gun to make sure all the joints melted together. I then took some short red strips and warmed them in the water, and added them to the mask, folded in half, so that both ends were joined to the top edge.

I laid a gold strip onto a small piece of non stick craftsheet and melted it with a heat gun, then used a 4 petal cutter to cut a 'flower'. I dropped the FP and craft sheet into a bowl of water to cool, then made lots more petal shapes in gold and indian red.

I dropped the 'flowers' into the hot water to soften them, then attached them to the mask, trying to spread them evenly over the 'ribbon' framework, and ensure a balanced mixture of gold and red. It's quite sturdy, but nicely lightweight. And my daughter can be certain that her mask is unique!!!!